- PRODUCT PROPERTIES:
➢ High-quality, two-component, water-dispersed modified amine epoxy floor coating.
➢ Forms a hard, abrasion-resistant coating with an aesthetically pleasing satin-matt finish.
➢ Excellent adhesion to dry or slightly damp mineral substrates (cement-based).
➢ Resistant to water, diluted acids, alkaline solutions, as well as a wide range of organic chemicals.
- AREAS OF APPLICATION:
➢ Decorative and protective coating for mineral (cement-based) substrates exposed to mechanical and chemical stresses.
➢ Suitable for areas subjected to light to medium mechanical loads.
➢ Recommended for use in manufacturing plants, canteens, electronics and pharmaceutical industries, as well as office buildings and similar facilities.
- PRODUCT CHARACTERISTICS:
| Cleaning agent | Water. |
| Colours | Grey, blue, red, yellow, green, etc.
Custom colours available upon request; however, some dark shades may not be suitable for industrial flooring applications. Please contact MC-BIFI for further advice. |
| Packaging | 19.25kg / set. |
| Shelf life & Storage | Can be stored for 12 months in unopened original packaging under cool (below 20°C) and dry conditions. Protect from frost. |
| Disposal | Ensure that single-use containers are completely emptied before disposal, in accordance with local regulations. |
- TECHNICAL DATA:
| Characteristic | Unit | Value | Comments |
| Mixing ratio (by weight) | 3 : 8 | Base : Hardener | |
| Density | g/cm³ | ~ 1.3 – 1.4 | Depending on colour |
| Viscosity | mPa·s | ~ 1.500 | At 20°C and 50% RH |
| Working time | minutes | ~ 30 | At 20°C and 50% RH |
| Touch dry | hours | ~ 12 | At 20°C and 50% RH |
| Full cure | days | 7 | At 20°C and 50% RH |
| Application conditions | °C
% K |
≥ 8 – ≤ 30
≤ 85 3 |
Air and substrate temperature
Relative humidity Substrate temperature above dew point |
| Consumption | kg/m² | ~ 0.15 – 0.3 | Per coat |
(*)Technical values determined under standard laboratory conditions (21°C ± 2°C, 50% RH). The coverage is theorotical and may vary due to a variety of site conditions.
- INSTRUCTION OF USE:
➢ Primer: Concrete substrates must be primed with MC-EP Primer W. The primer should be evenly applied using a rubber squeegee and/or a short-pile roller. The use of a transparent primer coat is recommended to optimise adhesion and surface appearance.
➢ Application:
– After the primer has fully dried (waiting time approx. 12 – 48 hours), apply MC-Floor 1011 with a short-pile roller in crosswise directions, ensuring a streak-free finish and adherence to the specified consumption rate.
– Typically, two coats are needed to achieve color uniformity and optimal results. The waiting time between the two coats is a minimum of 12 hours and a maximum of 48 hours.
– Coatings must be applied continuously, efficiently and without forming overlaps or joints.
– To ensure optimal drying: Minimum surface and air temperature: 10°C and permissible relative humidity: maximum 85%.
➢ General information:
– Consumption rate, application time, resistance to foot traffic and time to full cure depend on temperature, environmental conditions and the condition of the substrate on site.
– To ensure colour consistency between different production batches, the instructions in the technical documentation must be observed.
– Exposure to chemicals and UV radiation may lead to colour changes over time; however, this does not generally affect the performance or usability of the coating.
– Surfaces exposed to mechanical and chemical stresses are subject to wear during service. Regular inspections and routine maintenance are recommended.
